If my 740A is not responding to the remote control, what can I do?

Whilst the obvious answer is to check the batteries in the remote, it is also important to note that there is a set of 4 dip-switches on the rear panel of the 740A which, if set incorrectly, will turn off the remote control receiver in the front panel of the amplifier.

If these switches have been moved or knocked, ensure that the switch marked 'Front Panel IR' is set to the 'On' position.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Powered by Zendesk